csr04 Ultrasonic Sensor with atmega328p 2021 Proteus Simulation
Ultrasonic
Sensor HC-SR04 and Arduino Tutorial
How the HC-SR04 Ultrasonic Sensor Works
It emits an ultrasound at 40 000 Hz which travels
through the air and if there is an object or obstacle on its path It will
bounce back to the module. Considering the travel time and the speed of the
sound you can calculate the distance.
The HC-SR04 Ultrasonic Module has 4 pins, Ground, VCC, Trig
and Echo. The Ground and the VCC pins of the module needs to be connected to
the Ground and the 5 volts pins on the Arduino Board respectively and the trig
and echo pins to any Digital I/O pin on the Arduino Board.
Components needed for this tutorial
You can get these components from any of the sites
below:
- Ultrasonic Sensor HC-SR04
- Arduino Board
- Breadboard and Jump Wires
In order to generate the ultrasound you need to set the Trig
on a High State for 10 µs. That will send out an 8 cycle ultrasonic burst which
will travel at the speed of sound and it will be received in the Echo pin. The Echo pin
will output the time in microseconds the sound wave traveled.
For example, if the object is 10 cm away from the sensor, and
the speed of the sound is 340 m/s or 0.034 cm/µs the sound wave will need to
travel about 294 u seconds. But what you will get from the Echo pin will be
double that number because the sound wave needs to travel forward and bounce
backward. So in order to get the distance in cm we need to multiply the
received travel time value from the echo pin by 0.034 and divide it by 2.
This post is about interfacing hcsr04 ultrasonic sensor with avr microcontroller atmega328p. The mcu will measure the sensor using hcsr04 and show the output on a 16x2 LCD display. This video also shows interfacing LCD display with Avr microcontroller. Although, the same code can also be used for atmega32 and atmega8 Avr microcontrollers.
SOURCE CODE :- GITHUB
proteus simulation
Post a Comment