csr04 Ultrasonic Sensor with atmega328p 2021 Proteus Simulation

Introduction

Download the Arduino Software (IDE)

https://www.arduino.cc/en/main/software

You can directly download the Arduino 1.8.7 from the above link or visit Arduino’s Download Page to choose between the Installer (.exe) and the Zip packages.

It is recommended to install using the above Executable Installer as it will install the required drivers and you don’t have to install it manually. 

What You Will Learn

• How to Install Arduino IDE in Windows OS?
• How to Install COM Port Drivers of Arduino in Windows OS?
• How the flash Arduino code from Arduino IDE?

Installation Steps

Time needed: 5 minutes.

Installation Steps for Arduino IDE and Drivers

1. License Agreement

   Please accept the License Agreement to proceed with the installation process of Arduino IDE and Drivers.
   
   

2. Installation Options

   Choose the options you required. If you are installing for the first time it is recommended to select the Driver option also.
   
   

3. Installation Folder

   Select the preferred installation directory.
   
   

4. Installation Progress

   It will take few seconds to minutes for the installation.
   
   

5. Arduino Driver Installation

   Trust and install the Arduino Drivers.
   
   

6. Testing Arduino and COM Port Selection 

   Connect the Arduino Board and open the Arduino Application. Go to Tools->Port and then select the COM Port which represents your Arduino Board. If you are using a clone board then you may not see the “Arduino” after it.
   
   

7. Arduino Board Selection 

   Select the Arduino Board that you are using. Select this carefully as wrong selection will lead to failed upload of program.
   
   

8. Processor / Microcontroller Selection 

   Select the proper Microcontroller you have on your Arduino Board and select the correct one as the wrong choice will give a programming error.
   
   

9. Test the Arduino Board using Blink Application 

   Go to File -> Examples -> 01.Basics -> Blink and open the Blink Program of Arduino that will blink a Board orange LED every 1 Second. This will verify your Toolchain and Hardware Setup.
   
   

10. Build your Arduino Program 

    Select the “Upload” / “->” Arrow Button. The Sketch should Compile.
    
    

11. LED Blink Program Upload

    After the program is flashed and you get “Done uploading” the On-Board LED should flash every 1 Second. This Confirms everything is working as expected.